RF TV level alarms

RFTV is a low-cost RF level converter, suitable for any UHF TV equipment with an output power test-point.

The output level is continuous and, to obtain the best precision on the entire scale, is corrected by ANT SW. These converters are connected directly to the RF output test point of the equipment.

RFTV has two operating modes: Reading or Alarm.

• In reading mode, you can read the output voltage proportional to the RF input level
• In alarm mode, the probe works like an open contact: when the reading of the equipment under control is lower than a preset level, a contact to ground is closed.

Power requirement

12VDC @ 40mA max

I/O Range

Power Range: -5 ÷ +12 dBm
Frequency Range: 400 ÷ 900 MHz
Output Range Reading mode: 0 ÷ 5VDC
Alarm mode: Contact to ground closure